NYLON HOLSTER
This cordless screwdriver is equipped with
a holster that provides a convenient
method of keeping both the tool and the
bits close at hand. This function is
particularly handy when performing
repetitive operations.
Attach the holster to a belt on the right
hand side for easy access to the bit
pockets:
1. Pull the loop strap (1) away from the
hook strip (2) on the inside of the
holster (Fig. 7).
2. Slide the opened loop strap over the
belt (3).
3. Firmly press the loop strap onto the
hook strip so it forms a belt loop that
will hold the holster in place on the
belt.
4. Place the cordless screwdriver (4) in
the holster (Fig. 8).
NOTE: When placing the tool in the
holster, do not push it too far into the
holster to avoid the switch from being
turned ON.
5. Place required accessory bits (5) and
pencil (6) in pockets as shown.
To Next Page
Loading...
Need help?
General
