MasterCraft 054-3175-8 User Manual

20V max* LITHIUM-ION CORDLESS IMPACT DRIVER - 054-3175-820V max* LITHIUM-ION CORDLESS IMPACT DRIVER - 054-3175-8
15 16
PROBLEM POSSIBLE CAUSES SOLUTIONS
The impact driver does
not work
The battery is depleted Charge the battery
The bit cannot be
installed
The sleeve is not released Release the sleeve
The bit does not fit the sleeve Use a suitable bit
The motor overheats Be sure the cooling vents are free
of dust and obstacles
Clean and clear vents. Do not
cover with hand during operation
WARNING!
Turn the trigger switch to the “OFF” (centre) position and remove the battery from the
power tool before performing troubleshooting procedures.
Iftheproblemremainsunsolvedafterperformingthechecksdescribedabove,callthetoll-
freehelplineat1-800-689-9928.
TROUBLESHOOTING
Beforeeachuse
1. Inspect the cordless impact driver, the trigger switch, and the battery pack for damage.
2. Check for damaged, missing, or worn parts.
3. Check for loose screws, misalignment or binding of moving parts, or any other condition that may
affect the operation.
4. If abnormal vibration or noise occurs, turn the tool off immediately and have the problem corrected
before further use. Remove the battery from the power tool before cleaning or performing any
maintenance. Using compressed air may be the most effective cleaning method. Always wear safety
goggles when cleaning tools using compressed air.
WARNING!
Do not allow brake fluids, gasoline, petroleum-based products, penetrating oil, etc. come
into contact with plastic parts. These substances contain chemicals that can damage,
weaken, or destroy plastic.
WARNING!
When servicing, use only identical replacement parts. The use of any other parts may
create a hazard or cause damage to the product.
WARNING!
Use only accessories that are recommended for this cordless impact driver by the
manufacturer. Accessories that may be suitable for one tool may become hazardous when
used with another tool.
WARNING!
To ensure safety and reliability, all repairs should be performed by a qualified service
technician.
MAINTENANCE

MasterCraft 054-3175-8 Specifications

General

Brand	MasterCraft
Model	054-3175-8
Category	Impact Driver
Language	English