3
WARNING! READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS
BEFORE USING THIS EQUIPMENT. Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious personal injury or property damage.
II. General safety guidelines
1. FOR YOUR OWN SAFETY, READ THE INSTRUCTTION MANUAL BEFORE OPERATING
THE MACHINE. Learning the machine’s application, limitations, and specific hazards will greatly
minimize the possibility of accidents and injury.
2. KEEP GUARDS IN PLACE and in working order.
3. REMOVE ADJUSTING KEYS AND WRENCHES. Form a habit of checking to see that keys and
adjusting wrenches are removed from tool before turning it on.
4. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
5. DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power tools in damp or wet locations,
Woodworking can be dangerous if safe and proper operating procedures are not followed. As with
all machinery, there are certain hazards involved with the operation of the product. Using
the machine with respect and caution will considerably lessen the possibility of personal injury.
However, if normal safety precautions are overlooked or ignored, personal injury to the operator
may result. Safety equipment such as guards, push sticks, hold-downs, featherboards, goggles,
dust masks and hearing protection can reduce your potential for injury. But even the best guard
won’t make up for poor judgment, carelessness or inattention. Always use common sense and
exercise caution in the workshop. If a procedure feels dangerous, don’t try it. Figure out an
alternative procedure that feels safer. REMEMBER: Your personal safety is your responsibility.
WARNING! This machine was designed for certain applications only. Mastercraft
®
machinery
strongly recommends that this machine not be modified and/or used for any application other
than that for which it was designed. If you have any questions relative to a particular application,
DO NOT use the machine until you have first contacted Mastercraft
®
to determine if it can or
should be used on the product.
WARNING! SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING,
AND OTHER CONSTRUCTION ACTIVITES contains chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products,
• Arsenic and chromium from chemically-treated lumber.
Your risk from exposure varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved safety
equipment, always wear MSHA/NIOSH approved, properly fitting face mask or respirator when
using such tools.
WARNING! FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL
INJURY.
To Next Page
Loading...
Need help?
General
