LOADING THE TOOL WITH BRAD
NAILS
1. Remove the plug from the power
source.
2. Squeeze the magazine latch (1)
(Fig. 1).
3. While squeezing on the magazine
latch, slide the magazine out (2) as far
as it will go (Fig. 2).
WARNING: For safety reasons, the operator must read the sections of this
Owner’s Manual entitled “GENERAL SAFETY WARNINGS”, “POWER TOOL
SAFETY”, “SPECIFIC SAFETY RULES”, “EXTENSION CORD SAFETY” and
“SYMBOLS” before using this nailer/stapler.
Verify the following every time the nailer/stapler is used:
1. Safety glasses are being worn.
2. Proper brad nails or staples are installed in the tool.
3. Workpiece is properly secured.
4. There are no “live” wires in the area where nails or staples are being driven.
Failure to adhere to these safety rules can greatly increase the chances of
injury.
To Next Page