MasterCraft 058-8122-6 User Manual

OPERATING INSTRUCTIONS
17
AIR-POWERED PIN NAILER 058-8122-6
Firing modes
The Mastercraft
®
Air-powered Pin Nailer is
equipped with a single sequential actuation
mode.
1. Press the safety stand (1) against the
workpiece (2)
(fig F) .
2. Pull the trigger (1) to drive the nail with
the safety stand (2) firmly pressed
against the workpiece
(fig G) .
3. If the safety stand remains pressed,
successive nails will fire each time the
trigger is pulled.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• The safety tip must be in contact with the workpiece before activating the
tool.
• Do not operate the tool if the nails are not loaded, as doing so may damage
the tool.
• Do not fire nails into the air, as doing so may cause injury to the operators
or others, apart from damaging the tool.
• Load the correct type of nails only. Failure to comply could lead to serious
injury or loss of life.
MC-588122-08
2
1
fig F
MC-588122-09
1
fig G
2

MasterCraft 058-8122-6 Specifications

General

Brand	MasterCraft
Model	058-8122-6
Category	Nail Gun
Language	English