OPERATING INSTRUCTIONS
19
AIR-POWERED PIN NAILER 058-8122-6
• Operate the magazine latch and slide the pusher back to open the magazine for checking the
jammed nails.
• Use pliers or any appropriate tool to remove the jammed nails.
• Close the magazine cover and slide the pusher to its original position.
• Reload the nails into the tool magazine.
• Reconnect the air supply line to the tool’s air inlet.
• Test fire 3 to 5 nails into a piece of scrap wood in order to ensure a proper operation.
Note: If the nails continue to jam, call 1-800-689-9928.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Disconnect the tool from the air supply line before clearing a jammed nail.
Failure to comply could cause them to be fired out of the tool causing serious
injury.
• Do not point the tool towards the operator or other people. Serious personal
injury could result if these instructions are not followed.
To Next Page
Loading...
