Need help?Do you have a question about the MasterCraft 058-8195-2 and is the answer not in the manual?
General| Input Voltage | 120V |
|---|---|
| Duty Cycle | 20% @ 90A |
| Wire Feed Speed | Variable |
| Welding Process | MIG (GMAW) |
| Wire Size (mm) | 0.8-0.9 mm |
| Wire Size | 0.023 - 0.035 in |
Steps to install the welder handle, including hardware and alignment.
Procedure for removing and installing the wire drive roller and related components.
Guidance on correctly holding the welding torch for optimal control and welding results.
Specifies the recommended distance between the torch nozzle and the workpiece.
Instructions for adjusting wire speed for proper arc characteristics and weld quality.
Details on torch travel, travel speed, and types of welding beads (stringer, weave).
Guidance for welding in flat, horizontal, vertical, and overhead positions.
Techniques for butt weld and fillet weld joints requiring multiple passes.
Explains three methods for spot welding: burn-through, punch and fill, and lap spot.
Recommended procedures for cleaning, inspection, and upkeep of the welding equipment.
Identification of common welding problems and their corresponding solutions for the welder.
An exploded view and list of all replacement parts for the Mastercraft welder.
Details on the product's limited warranty period, coverage, and additional limitations.
To Next Page
