22 23
model no. 058-8195-2 | contact us 1-800-689-9928
TROUBLESHOOTING
TROUBLESHOOTING
MAINTENANCE
The welder does not
work when the main
switch is turned on.
The welder does not
weld.
Blown fuse or
tripped circuit breaker.
Arc is hard to start.
1. No power input.
2. Power cord or power plug is
broken.
3. Main switch is broken.
4. Transformer is broken.
1. Incorrect power input.
2. Inadequate current at the output.
3. Poor connection of output cable.
4. Dirty surfaces.
5. Wrong welding wire.
Inadequate fuse or circuit
breaker.
1. Wrong welding wire.
2. Base metal not grounded
properly.
1. Check the circuit or fuse of
the power supply.
2. Replace the power cord.
3. Replace the main switch.
4. Replace the transformer.
1. Check the power source.
3. Check the output connection.
4. Clean the surfaces.
5. Use the correct wire.
If the problem persists, send
it for servicing or
return back to the store.
2. Check for proper grounding
to the workpiece.
Check whether the fuse
in power supply is 20 A.
If the problem persists,
send it for servicing or
return back to the store.
1. Use the correct wire.
2. Make sure the
connection is good.
If the problem persists,
send it for servicing or
return back to the store.
PROBLEM POSSIBLE CAUSES SOLUTIONS
model no. 058-1294-8 | contact us 1-800-689-9928model no. 058-1294-8 | contact us 1-800-689-9928model no. 058-1294-8 | contact us 1-800-689-9928
model no. 058-8195-2 | contact us 1-800-689-9928
WARNING!
• Unplug the welder before performing any maintenance or service.
• Only use the welder after replacing or repairing any damaged parts or
accessories.
• Use only recommended and properly rated replacement parts. Failure to
comply could lead to serious injury or loss of life.
Potential hazard that could result in serious injury or loss of life.
The welder needs regular maintenance.
• Periodically clean dust, dirt, grease, etc. from your welder. Every six months, or as necessary,
remove the cover panel from the welder and air-blow any dust and dirt that may have
accumulated inside the welder.
• Replace power cord, ground cable , ground clamp, or electrode assembly when damaged or worn.
• Store in a clean dry facility, free from corrosive gas, excess dust and high humidity. Store in a
temperature range from -12 to 49ºC (10 to 120ºF) and relative humidity not more than 90%.
• When transporting or storing the welder after use, it is recommended to repack the product as it
was received for protection. Cleaning is required before storage and you must seal the plastic
bag in the box for storage.
MAINTENANCE
To Next Page
Loading...
Need help?
General
