MasterCraft 058-8691-0 User Manual

TROUBLESHOOTING
23
AIR-POWERED BRAD NAILER 058-8691-0
Note: For further repair information, please call 1-800-689-9928.
The tool does not
operate properly - it
does not drive the
nails or operates
sluggishly.
1. The air supply is inadequate.
2. Lubrication is inadequate.
3. The O-rings or seals are worn or
damaged.
4. The air deflector in the cylinder
head is blocked.
1. Verify that the air supply is adequate.
2. Pour up to 6 drops of oil into the air inlet.
3. Inspect and replace O-rings or seals.
4. Replace the damaged internal parts.
The tool skips nails.
1. The bumper is worn or the spring
is damaged.
2. There is dirt in the front plate.
3. Nails cannot move freely in
the magazine because of dirt or
damage.
4. The O-ring on the piston is worn
or dry or there is not enough
lubrication.
5. The cylinder cover seal is leaking.
1. Replace the bumper or pusher spring.
2. Clean the drive channel on the front plate.
3. Clean the magazine.
4. Replace the O-ring.
5. Replace the sealing washer.
The tool jams.
1. Improper nails are used, or
nails are damaged.
2. The driver guide is damaged or
worn.
3. The screw of the magazine is
loosened.
4. There is dirt in the magazine.
See section “Clearing a jammed nail” for
instructions.
1. Change and use appropriate nails.
2. Inspect and replace the driver.
3. Tighten the magazine.
4. Clean the magazine.
PROBLEM POSSIBLE CAUSES SOLUTIONS

MasterCraft 058-8691-0 Specifications

General

Brand	MasterCraft
Model	058-8691-0
Category	Nail Gun
Language	English