MasterCraft 058-8691-0 User Manual

OPERATING INSTRUCTIONS
17
AIR-POWERED BRAD NAILER 058-8691-0
Firing modes
The Mastercraft
®
Air-powered Brad Nailer is equipped with a single sequential actuation mode.
1. Press the safety stand against the workpiece.
2. Pull the trigger in order to drive the nail with the safety tip pressed firmly against the
workpiece.
3. If the safety stand remains pressed, successive nails will fire each time the trigger is pulled.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• The safety stand must be in contact with the workplace before activating the
tool.
• Do not operate the tool if the nails are not loaded, as doing so may damage
the tool.
• Do not fire nails into the air, as doing so may cause injury to the operators
or others, apart from damaging the tool.
• Do not load different sized nails into the magazine, as doing so may cause
nails to jam. Failure to comply could lead to serious injury or loss of life.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• Operate the tool with the utmost care when it is connected to the air
compressor. Failure to comply may result in moderate injury or damage to
equipment.

MasterCraft 058-8691-0 Specifications

General

Brand	MasterCraft
Model	058-8691-0
Category	Nail Gun
Language	English