headline bars
continuation tabs
notes
warnings
11
OPERATING INSTRUCTIONS
UNFOLD THE SHAFT
(fig 1-fig 2)
1. Remove the battery pack from the trimmer.
2. Put the trimmer on the ground and carefully unfold
the shaft. Make sure that the cable is inside the
shaft so that it will not be pinched when closing the
joints.
3. Use the wrench (included) to lock the shaft with the
hexagon screws supplied.
OPERATING INSTRUCTIONS
fig 1
WARNING!
• Always take care to not allow the shaft to pinch the cable when you are unfolding or folding the string
trimmer. Do not attempt to start the trimmer until the shaft has been locked.
NOTICE: To fold the shaft again, remove two hexagon screws near the rear handle side.
fig 2
Hexagon
screws
To Next Page
Loading...
Need help?
General
