MasterCraft 5296 - Page 9

headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
9
SAFETY GUIDELINES
• Before performing any kind of work on the machine (e.g., maintenance, tool change,
etc.), or when transporting and storing the tool, always set the direction-of-rotation
switch to the centre (locked) position. Unintentional activation of the On/Off switch may
result in personal injury.
• Do not open the battery. There is a risk of a short circuit.
• Protect the battery from heat and fire. There is a risk of explosion.
• Wear ear protectors when using the drill/driver. Exposure to noise can cause hearing loss.
• Use protective gloves when removing the bit from the tool, or first allow the bit to cool
down. The bit may be hot after prolonged use.
• Use protective gloves when operating the tool. Protective gloves can help to keep you from
being burnt or injured.
• Keep your hands away from the motor-housing vents. Hot gas comes from the vents
during operation.
• Release the trigger immediately when a screw is tightened to avoid breaking the
screw.
WARNING!
To reduce the risk of electric shock or damage to the charger and battery, use only the
Mastercraft
®
batteries and chargers listed.
BATTERY PACK CHARGER
054-3124-0, 054-7553-4,
054-7557-6, 054-2434-8
054-3126-6, 054-7559-2
• Keep the cord and charger from heat to prevent damage to the housing or internal
parts.
• For best results, your battery tool should be stored and used in a location where the
temperature is more than 5°C (41°F) but less than 40°C (104°F). Do not store outside or
in vehicles.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
................. Alternating current