20V max* LITHIUM-ION COMPACT CORDLESS IMPACT WRENCH - 054-3121-6
14
OPERATING INSTRUCTIONS
Loosening fasteners
1. With the proper impact socket securely mounted to the cordless impact wrench, slide the impact socket
onto the bolt head.
2. Verify that the rotational direction is “reverse.”
3. Hold the tool securely with both hands and squeeze the trigger switch. The tool will start to impact
immediately.
4. Once the fastener has “broken loose” it will start to unthread. Be careful that you do not allow a fastener
to spin freely once it is no longer engaged with the other threaded part, as it may be thrown out of the
socket.
Installing or removing bits (g 7)
1. Lock the trigger switch by placing the direction-
of-rotation selector in the OFF (centre) position.
2. To install or remove a 1/2" hex adaptor (available
separately), pull the back sleeve of the 1/2"
hex adaptor forward and press the hex adaptor
onto the square drive. Make sure that the steel
retention ball engages into the hole on the square
drive. To remove the hex adaptor, simply grip the
back sleeve and pull it off.
3. To install the bit, pull the front sleeve forward, hold
it in place, insert a 1/2" bit into the hexagonal chuck, and then release the sleeve. Check that the sleeve
returns to its original position and the bit is securely held in place. To remove the bit, pull the front sleeve
forward and pull the bit off.
fig 7
Steel retention ball
Front sleeve
Back sleeve
To Next Page
Loading...
Need help?
General
