WARNING: To avoid electrical hazards, fire hazards or damage to the heat
gun, use proper circuit protection.
The heat gun is wired at the factory for 110–120 V operation. It must be connected to
a 110–120 V, 15 A time delayed fuse or circuit breaker. To avoid shock or fire,
replace power cord immediately if it is worn, cut or damaged in any way.
ALWAYS WEAR EYE PROTECTION THAT CONFORMS WITH CSA
REQUIREMENTS or ANSI SAFETY STANDARD Z87.1
FLYING DEBRIS can cause permanent eye damage. Prescription
eyeglasses ARE NOT a replacement for proper eye protection.
WARNING: Non-compliant eyewear can cause serious injury if broken
during operation of a power tool.
WARNING: Some dust created by power sanding, sawing, grinding, drilling
and other construction activities contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
Lead from lead-based paints
Crystalline silica from bricks, cement and other masonry products
Arsenic and chromium from chemically-treated lumber
Your level of risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals, work in a well-
ventilated area and work with approved safety equipment such as dust masks
that are specially designed to filter out microscopic particles.
WARNING: Use hearing protection, particularly during extended
periods of operation of the tool or if the operation is noisy.
SAVE THESE INSTRUCTIONS FOR REFERENCE
WARNING: Always wear a dust mask designed to protect you from
dust created by your power tool.
WARNING: Use protective gloves to protect your hands from burns.
To Next Page