GUIDELINES FOR USING EXTENSION CORDS
Make sure your extension cord is in good condition. When using an extension cord, be sure
to use one that is heavy enough to carry the current that your product will draw. An
undersized cord will cause a drop in line voltage, which will result in loss of power and
overheating. The table below shows the correct size to be used according to cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
Minimum Gauge for Extension Cords (AWG)
(when using 120 V only)
Be sure your extension cord is properly wired and in good condition. Always replace a
damaged extension cord, or have it repaired by a qualified person before using it.
Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Use a separate electrical circuit for your tools. This circuit must consist of not be less than
#12 wire, and should be protected with a 15 A time-delayed fuse. Before connecting the
motor to the power line, make sure the switch is in the OFF position and the electric current is
rated the same as the current stamped on the motor nameplate. Running at a lower voltage
will damage the motor.
SAVE THESE SAFETY RULES
WARNING:
THIS TOOL MUST BE GROUNDED WHILE IN USE IN ORDER TO PROTECT
THE OPERATOR FROM ELECTRIC SHOCK.
WARNING:
THIS THICKNESS PLANER IS INTENDED FOR INDOOR USE ONLY. DO
NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS.
IV. Electrical information (continued)
9
Ampere Rating Total Length of Cord in Feet (metres)
More Than Not More Than 25' (7.6 m) 50' (15 m) 100' (30.4 m) 150' (45.7 m)
0 6 18 16 16 14
6 10 18161412
10 12 16 16 14 12
12 16 14 12 Not recommended
To Next Page
Loading...
Need help?
General
