model no. 055-3503-6 | contact us 1-800-689-9928
4
5
SAFETY GUIDELINES
!
Failure to follow these rules may result in serious personal injury.
WARNNING !
GENERAL SAFETY GUIDELINES BEFORE USING THIS POWER TOOL
SPECIFICATIONS
• Always wear safety glasses complying with OSHA/ANSI requirements Z87.1.
• Wear a mask or respirator when dust is generated.
• Keep bystanders out of the work area while operating the tool.
• Wheel guards and eye shields must be properly adjusted and tightened
• Always make sure wheels are properly mounted.
• Stand to the side of the grinder during start-up. Switch it on and let the grinder
operate at full speed for approximately one minute so that any undetected flaws or
cracks will become apparent.
• Use only 40 W (max.) bulbs on the work light.
• Use only 6” wheels suitable for 2000 RPM or over.
• Do not operate with cracked or chipped wheels.
• Keep guards in place and working properly.
• Keep hands clear of grinding wheels.
• Never reach behind or beneath the grinding wheels.
• Unplug from power supply before adjusting or servicing. The grinding wheels continue
to rotate after the tool is switched off. Always allow wheels to stop before adjusting
or servicing.
• To avoid electric shock, DO NOT use in damp conditions or expose to rain.
• When fitting a new grinding wheel, always check that the stated maximum RPM meets
or exceeds that stated on the grinder. Also check the new wheel for damage, such as
flaws or cracks. If the wheel appears satisfactory, fit it to the grinder.
• When a new grinding wheel has been fitted, stand to one side of the grinder and
switch it on. Let the grinder operate at full speed for approximately one minute so
that an undetected flaws or cracks will become apparent.
• Use only accessories that are recommended by the manufacturer for your model.
• DO NOT attempt to cut anything with the grinding wheel.
• Grounded tools must be plugged into an outlet that has been properly installed
and grounded in accordance with all local codes and ordinances. Never remove the
grounding prong from the plug or modify it in any way. Do not use adaptor plugs. If in
doubt as to whether the outlet is properly grounded, consult a qualified electrician.
• Do not use the tool when tired or under the influence of drugs, alcohol or medication.
• Do not wear gloves, neckties, jewellery or loose clothing when using tool.
• Ensure the power switch is off prior to plugging in the tool.
• Do not overtighten spindle nuts.
• Spacing between tool rests and wheels should be set to 1/8” or less; hold workpiece
firmly against tool rest.
• Service on these tools should only be performed by an authorized, qualified
technician.
• Secure the tool when working to prevent unexpected movement.
• Failure to comply with these warnings may result in serious personal injury.
• There is a risk of injury due to accidental starting; do not use this tool in an area where
children may be present.
SPECIFICATIONS
MOTOR 120 V AC, 60 Hz, 2.5A
WHEEL SIZE 6 x 3/4" (15.2 x 1.9 cm) with 1/2" (1.27 cm) arbour
WHEEL GRIT 36- and 60-grit
VARIABLE SPEEDS 2000-3400 RPM (No load)
WEIGHT 25 lb 6 oz (11.5 kg)
To Next Page
Loading...
Need help?
General
