2016 OWNERS MANUAL / 0247
Special Attention
On the X2, X10, X30, X46, and XSTAR models, GEN2 WSDs are
limited to seventy-five percent (75%) maximum extension when the
boat speed exceeds twenty miles per hour (20 mph) or thirty-two
kilometers per hour (32 km/h).
On the X20 and X23 models, GEN2 WSDs are limited to seventy-five
percent (75%) maximum extension when the boat speed exceeds
twenty five miles per hour (25 mph) or forty kilometers per hour
(40 km/h).
Maneuvering a boat with the WSDs extended requires
practice to master. Initial times running with the surf tabs extended
should be done at low speed with plenty of room. This is critical to
learning how the WSDs affect control and maneuverability, espe-
cially when actuating WSDs with the attitude adjustment plate(s).
Electromechanical actuators provide an instant response. When
making adjustments, use short momentary taps of the switch.
BALLAST SYSTEMS
Models
A triple hard tank ballast system is standard on all X-series and NXT
series boats. These ballast tanks cannot be removed after the boat
has been built due to tight tolerance to fit between the deck and the
Hull. The GEN2 Surf System, explained immediately previously to
this section has additional plug-in bags. The bags connect through
quick-connect fittings located in the rear storage compartment. The
ProStar ballast system is similar to the X-Series, but features a single
MTS. The NXT series has optional wake shaping devices and additional
quick-connect bags when selected, but does not come with the GEN2
software.
Purpose
Ballast systems were specially designed for each model of
MasterCraft boats to enhance enjoyment of boating. By creating
deeper, more dynamic waves in the wake, boarding enthusiasts
with skills ranging from beginners to professional boarders have
discovered more enjoyable, even record-setting experiences. For
simple outings and quicker reaction by the boat, ballast systems can
be left empty. Filling ballast tanks, and optional bags, however, sets the
stage for exciting and fun experiences.
To Next Page
Loading...
