2016 OWNERS MANUAL / 0275
Models
Available as an option on all boats. There are two different types of
flushes and the installed option will depend on the boat model.
Purpose
Boats that will be operated in salt water (or brackish fresh water)
need to be rinsed after every use, including internal engine parts
where water has been drawn.
Location
The engine flush connection is on the transom, but varies on differ-
ent models.
Operation
The engine flush connection allows for quick and easy connection to
a shore-side garden hose or similar hose to quickly and easily flush
the engine. See the ILMOR Engine Owner’s Manual for additional
details regarding this important function. The flush connection is
located on the transom.
Troubleshooting
If a hose will not connect to the flush connection, locate a different
hose. Garden hoses work fine as long as the hose end is not bent or
misshapen.
If water will not enter through the flush connection, disconnect the
hose and check that there is no obstruction in the connection area.
If there is no obvious reason for the system malfunction, take the
boat to an authorized MasterCraft dealer for assistance.
HEAD AND TOILET SYSTEM
Model
X26, as an option
Purpose
The on-board head provides convenience for longer outings.
Location
The head is located forward of the observer seat, accessible
through a door that opens into the walk-thru area to the bow.
Operation
This boat is equipped with an Dometic Masterflush electric macer-
ating toilet. The Masterflush toilet has a rugged glass filled nylon
twin impeller that instantly draws in the effluent into the macerating
chamber where the waste is pulverized by a 10 blade stainless steel
To Next Page
Loading...
