2023 OWNER’S MANUAL
/
96
Using Rapid Surf to Select a Wave
Rapid Surf is intended to make wave customization a quick and
easy process. In a few simple steps, you can build an amazing surf
wave and hit the water in no time.
1. Before you begin setting up your wave, make sure that Surf Mode is
selected and that it is set to the Rapid Surf menu. When Rapid Surf
is active, the following screen will appear:
2. Locate the slider and arrows found on the left-hand side of the
screen. These controls allow you to choose from 7 Naval Preset
Profiles. Each Naval Preset has been designed to suit a particular
surf style. 1 is the mellowest, shortest wave and is suited to
beginners. 7 is the steepest, tallest wave and is suited to advanced
surfers. The average surfer will most likely opt for presets 3-5.
Note: For each of the 7 Naval Presets, there is a SURF LEFT and
SURF RIGHT variant. As a result, the operator has 14 Naval Presets
to choose from in total.
3. Use your finger to drag the slider to the desired wave preset.
Alternatively, use the arrows to the right of the slider.
4. Using the SURF LEFT/SURF RIGHT buttons, choose the position
of your surf wave. Selecting SURF LEFT will direct the surf tabs to
create a port-side wave. Selecting SURF RIGHT will direct the surf
tabs to create a starboard wave.
5. If you are satisfied with your wave and wish to save it as a preset for
later use, you may do so using the slot bar near the bottom of the
screen. This bar houses 6 slots in total. To store your wave in one of
these slots, press and hold any EMPTY slot.
To Next Page
Loading...
Need help?
General
