2016 OWNERS MANUAL / 0273
Operation
Most covers are intended for use when the boat is moored or
stored. These canvas covers will snap or ratchet into place. Howev-
er, the Bimini top offers shade while the boat is in use. The Bimini is
installed over the helm and/ or midsection of the boat. The Bimini
legs will fold to allow for minimal wind resistance during towing or
when riding across the body of water at higher speeds, or for stor-
age. When folding the legs be certain to be careful to avoid pinching
fingers when raising or lowering the legs. For balance, it is suggest-
ed that operators have an additional person assist when raising or
lowering a Bimini top.
Special Attention
MasterCraft strongly recommends having an authorized MasterCraft
dealer perform the installation of snap-on canvas such as cockpit
and tonneau covers, because snap installation can cause “crazing”
(unwanted spiderweb-like lines in the gel coat) if the installation is
not done correctly. Such damage is not covered under warranty.
Additional Special Attention
On-going care of the canvas is required to keep the material in good
condition for the life of the boat. See Cleaning the Boat section of
this Owner’s Manual for more information.
Additional Special Attention
Note that towing with unapproved covers on the boat may result
in damage to the gel coat. MasterCraft recommends the use of
our towable cover only for towing. Other canvas covers have been
developed and are available only through authorized MasterCraft
dealers for a variety of uses.
Additional Special Attention
The use of canvas covers, especially darkly colored ones, in hot,
sunny conditions, can result in temperatures inside the boat in ex-
cess of 140
o
F/60
o
C. Prolonged high temperatures can heat interior
metal and other surfaces to the point that brief contact with the
skin may cause serious burns. Carefully remove the cover and allow
the interior to ventilate and cool before allowing anyone on board.
To Next Page
Loading...
Need help?
General
