Page 8
ESTIMATED RUN-TIMES
APPLIANCE TYPE
EST
WATTAGE
APPROX.
USAGE
Cell phone,
fluorescent light
4 watts 34 hrs
Radio, fan,
depth finder
9 watts 14 hrs
Camcorder 15 watts 7 hrs
Electrical tool 24 watts 5 hrs
Electric cooler 48 watts 2 hours
Car vacuum,
air compressor
80 watts 1.8 hrs
NOTE: Actual time may vary. Times are based on
the internal battery being fully charged.
USING THE AIR COMPRESSOR
Read the instructions
of the product being inflated before using
the compressor. Avoid overinflation; do not
exceed the manufacturer’s recommended
pressures. Do not leave the air compressor
unattended during use.
NOTE: Wrap cleats are provided for conve-
nient storage of the air compressor hose.
Wrap the hose around these cleats when
the hose is not in use.
1.
Ensure the battery clips are securely on
the storage holders.
2.
Remove the air compressor hose from
the storage cleats.
3.
Connect the adapter to the valve stem
by threading it onto the end. If neces-
sary, use one of the additional adaptors.
4.
Press the air compressor power switch
to turn ON and inflate to the desired
pressure or fullness (refer to the gauge
next to the switch).
5.
When the desired pressure is reached,
press the air compressor power switch
to turn OFF and remove the connector
from the valve stem.
6.
Allow unit to cool.
7.
Recharge the unit before storing.
NOTE: The air compressor is rated for
150 PSI.
ESTIMATED TIME FOR INFLATING
Vehicle tires 13-16" 6-24 minutes
Bike tires 1-3 minutes
Sports balls 30 seconds
These times are approximate. Use the air com-
pressor gauge to ensure the proper pressure
has been reached. Do not overinflate.
5. MAINTENANCE INSTRUCTIONS
• After use and before performing main-
tenance, unplug and disconnect the
jump starter.
• Use a dry cloth to wipe all battery
corrosion and other dirt or oil from
the battery clips, cords and the jump
starter case.
• Ensure that all of the jump starter
components are in place and in good
working condition.
• All servicing should be performed by
qualified service personnel.
6. MOVING AND STORAGE INSTRUCTIONS
• Store inside, in a cool, dry place.
• Do not store the clips on the handle,
clipped together, on or around metal,
or clipped to cables. The clips on the
jump starter are live when the switch is
in the ON position and will produce arc-
ing or sparking if they come in contact
with each other. To prevent accidental
arcing, always place the switch in the
OFF position and keep the clips on the
storage holders when not using it to
jump start a vehicle.
• If the jump starter is moved around
the shop or transported to another
location, take care to avoid/prevent
damage to the cords, clips and jump
starter. Failure to do so could result in
personal injury or property damage.
IMPORTANT: Do not use and/or store the
jump starter in or on any area or surface
where damage could occur if the internal
battery should unexpectedly leak acid.
To Next Page
Loading...
