Page 11
PROBLEM POSSIBLE CAUSE SOLUTION
The unit won’t power my
12V device.
The 12V device is not
turned on.
The Portable Power’s
battery is not charged.
The 12V device draws
more than 15A or has a
short circuit.
Turn on the 12V device.
Check the battery charge
status by pressing the
button on the front of the
unit. See Digital Display
section.
Contact a qualified service
technician, to replace the
fuse.
The internal battery won’t
hold a charge.
The battery is bad (will not
accept a charge).
Have the battery checked.
The jump starter’s alarm
is on.
Connections are reversed. Disconnect the jump
starter and reverse the
clamps.
The inverter is on, but the
display only shows err.
The jump starter battery is
not fully charged.
The device is drawing
more than 400W or has a
short circuit.
Recharge the unit.
Use only devices that
draw less than 3.3 amps of
AC current.
The compressor shuts off
before reaching the set
pressure.
The compressor has a
thermal cutoff, to protect it
from overheating.
Wait a few minutes. The
compressor will start
up again and finish the
process.
8. SPECIFICATIONS
Internal battery type ............................... Sealed maintenance-free AGM lead-acid
Nominal voltage ............................................................................................. 12V DC
USB output .............................................................................................. 5V DC, 2.1A
Jump start ...............................................................................................1150A peak
9. REPLACEMENT PARTS
Air compressor accessory kit (3 hose adapters) ................................ 2299001425Z
10. ACCESSORIES
Male-to-male accessory cable .................................................................. 94500109
To Next Page
Loading...
