Page 18
Storage
• When your pressure washer session has
been completed, turn off the power switch.
Unplug the power cord from the outlet. Turn
off the water supply. Pull the trigger on the
spray gun 2-3 seconds to drain out the
excess water and to release any remaining
water pressure. Do not allow the pressure
washer to run with no water flowing through
it.
• Remove high pressure hose from spray
gun and unscrew the other end of the high
pressure hose from the pressure washer.
• Remove lance from the gun. Place the gun
and lance in the holster on the sides.
CARE AND MAINTENANCE
• The quick connect nozzles and rotary nozzle
are stored on the nozzle holder located on
both sides of machine.
•
DO NOT store the pressure washer where
it is exposed to freezing temperatures
unless you use an antifreeze designed
for pumps.
Store the pressure washer
indoors to prevent the water in the unit
from expanding under freezing conditions.
When the water freezes and expands, your
pressure washer will be damaged and
become inoperable. Or, if storing outdoors,
it is recommended you use pump saver (not
included) to protect pumps.
• Make sure to discard any remaining
detergent from the tank. Residual chemical
will stick to the container which could
become contaminated, and can cause the
detergent injector to clog and not function
properly. Flush the tank and nozzle head with
clear water to prevent clogging.
• Wind the power cord around the L-shaped
hooks located on the top of the machine.
• The pressure hose is stored on the hose
hook located on the back of the handle.
96050_IM_MF3N12300.indd 1896050_IM_MF3N12300.indd 18 2020/12/10 上午10:472020/12/10 上午10:47
To Next Page
Loading...
