MasterForce MF3N12300

Questions and Answers

L
Laura MitchellAug 6, 2025
Why does my MasterForce MF3N12300 Pressure Washer turn on for 2 seconds then shut off?
- K
  kimberly32Aug 7, 2025
  When the water is connected, the accessories are assembled properly, and the power is turned on, the MasterForce Pressure Washer may turn on for 1 - 2 seconds to prime the pump. It automatically shuts off and waits for the spray gun trigger to be pressed. When the trigger is pressed, water starts flowing through the pump. The water sensor in the pump 'senses' the moving water and automatically turns the pressure washer on. Alternatively, turn the power off, hold in the trigger on the spray gun so that you have a steady stream of water, and while you are holding the trigger open on the spray gun, at the same time, turn the power on.
B
Brian BrownAug 13, 2025
What to do if the high pressure hose won't connect to the MasterForce MF3N12300 Pressure Washer spray gun?
- J
  Jamie BakerAug 13, 2025
  The problem is likely the rubber sleeve covering the fitting at the end of the high pressure hose, which has likely slipped up toward the metal tip. Wiggle, twist, and/or pull the rubber sleeve down until the entire tip is visible plus an 1/8 in. of the metal fitting below the tip. Now try to insert the hose tip into the spray gun. It should “click” into place and will not come out until the hose is released by pushing in the lever on the underside of the gun. If you are unable to move the sleeve down, you may carefully cut away the end of the sleeve with a sharp knife, being careful not to cut or puncture the hose.
B
Brian HarveyAug 18, 2025
What to do if my MasterForce MF3N12300 is running but there is no water flow?
- J
  James Ellis Jr.Aug 18, 2025
  First, remember that power should NOT be turned on until water comes through the spray gun, as doing so will damage the motor. Then: * Check the water source. * Eject the nozzle from the lance to determine if the clog is coming from the nozzle. * Take off the lance and just spray out of the spray gun to see if the problem is with the lance. * Check the Garden Hose Adapter for loose connection and the filter for debris.
J
jeanetteloweryAug 26, 2025
How to remove the lance from the MasterForce MF3N12300 spray gun?
- S
  smithsusanAug 26, 2025
  All lances are attached and removed from the spray gun in the same manner. Insert the end of the lance into the spray gun. Press the spray gun and lance together (about a 1/8 in.) and turn the collar of the gun clockwise to lock the lance in place. To remove the lance, reverse this procedure by pressing the spray gun and lance together and turning counter-clockwise until the lance slides out. You can also hold the spray gun and lance in an upright position with the nozzle end on the floor and push the whole assembly straight down to loosen the connection, and then follow the removal process again. You may also spray soapy water or a lubricant in the area where the lance connects to the spray gun.
S
Sarah TaylorAug 31, 2025
Why is water leaking where the high pressure hose connects to the MasterForce MF3N12300 Pressure Washer spray gun?
- Y
  yturnerAug 31, 2025
  Make sure there is an o-ring at the end of the metal tip of the high pressure hose. If no o-ring is present, the connection between the hose and spray gun will leak. An O-Ring Replacement Kit is included with purchase.