Page 13
Pull forward on latches that are located on
each side of wall mount until latches snap in
correct position, locking pressure washer unit
to wall mount.
Refer to pressure washer unit (F) owner’s
manual for operation instructions for the
pressure washer.
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
FIG.26
• Make sure the power switch is off (light will
be off).
• Unwind the power cord completely and plug
into a grounded 120 volt outlet.
• Turn on water supply at the faucet to
completely open.
• Turn the safety lock button on the spray gun
to unlocked. While pointing the spray gun
in a safe direction, squeeze the trigger on
the spray gun until there is a steady stream
of water, letting the water and air out of the
hose.
K
lock
• Push the power button to turn the unit on
(green power light will turn on). The unit will
turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature.
• Squeeze the spray gun trigger to begin
pressure washing.
• Begin pressure washer by squeezing the
trigger on the spray gun all the way into the
handle.
• Release the spray gun trigger to stop the
pressure washer.
• Allow the motor to come to a complete stop
before squeezing the trigger again.
• Squeezing rapidly will cause the auto start
feature to miss an on/off cycle that may
prevent it from turning on while squeezing
trigger after rapid squeezing. Use slow,
deliberate trigger pulls to avoid this.
OFF ON
96050_IM_MF3N12300.indd 1396050_IM_MF3N12300.indd 13 2020/12/10 上午10:472020/12/10 上午10:47
To Next Page
Loading...
