Machine Checks
20
Machine Checks
Pre-Shift Checks
Check the battery display indicator (BDI) for sufficient charge level.
Check for leaks.
Check that the machine is fully intact and that there is no visible damage to the:
- Control head or controls
- Bodywork
- Coupling
- Drive or castor wheels
Weekly Checks
Clean dirt or grease off the machine.
Check that the coupling fixing bolts and nuts are tight.
Check the coupling surfaces for unusual wear, cracks or damage.
Check coupling clamps move freely and clamp firmly on the load.
Check that the anti-crush and emergency stop buttons work correctly.
Check that the key switch isolates the machine. Make sure none of the controls work when
switched off.
Check the battery cables, connectors, charger and protective outer wrapping for damage or
wear. If they are damaged do not use your machine.
Monthly Checks
Check that the terminals of the battery pack connectors are free from corrosion. If necessary,
clean the terminals and apply a small amount of light grease or petroleum jelly.
Note: Identification of any of the above should be reported to your line manager.
WARNING: CHECKING THE MACHINE
Ensure the machine is situated in a safe place before you carry out the
following checks.
To Next Page
Loading...
