2 SAFETY GUIDELINES AND WARNINGS
2.1 WARNINGS AND SYMBOLS
Safety instructions and warnings are marked in this manual
by the following pictograms:
A procedure, circumstance, etc which deserves
extra attention.
CAUTION!
Special information, commands and
prohibitions in order to prevent damage.
WARNING
A WARNING refers to possible injury to the user
or installer or significant material damage to the
Soladin if the installer / user does not
(carefully) follow the stated procedures.
2.2 USE FOR INTENDED PURPOSE
The Soladin Web is constructed as per the applicable safety-
technical guidelines. Use the Soladin Web inverter only in
installations that meet the following qualifications:
• the electrical installation must meet the applicable
regulations and standards (must be carried out correctly)
and must be in a good condition;
• according to the technical specications.
WARNING
Never use the Soladin Web in situations
where there is danger of gas or dust explosion
or potentially flammable products!
Use of the inverter other than as mentioned under section 2.2
is considered to be conflicting with the intended purpose.
In such cases, Mastervolt will not accept liability for any
damage or injury caused by the functioning or malfunctioning
of the inverter.
2.3 INSTALLATION, MAINTENANCE, REPAIR
WARNING
As dangerous voltages exist, only allow
installation, maintenance and repair of the
Soladin Web to be carried out by
qualified electricians.
Connections and safety features must be executed
according to the locally applicable regulations.
In case of decommissioning and/or demounting follow
the instructions as stated in this manual. If repairs or
replacements are required, only use original Mastervolt spare
parts. Make sure two persons are present when working on
the installation, at least until the installation has been de-
energized and verified by a suitable metering instrument.
2.4 WARNING OF SPECIAL DANGERS
Two primary energy sources are present:
• solar panels (DC)
• utility grid (AC).
Switch off both sources before starting any
work on the installation. Block the switching
device against unintentional reconnection.
Verify the de-energizing of both DC and AC
connections using a suitable metering
instrument.
The voltages present at the grid and solar side
of the Soladin are not safe to touch.
WARNING
Life danger caused by high electric voltages
present at the connectors after disconnecting
DC and AC. After 1 minute the connectors are
voltage free.
To Next Page
Loading...
Need help?
General
