EasyManua.ls Logo

Mat-Tuner mAT-125E User Manual

Mat-Tuner mAT-125E
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
MAT-TUNER
®
1 / 6
mAT-125E
HF-SSB General Automatic Antenna Tuner
Instruction Manual Version V3.0
INTRODUCTION
mAT-125E is a universal automatic antenna tuner that can be used in most HF transceivers. It
has a working frequency range of 1.6-54MHz and a maximum allowable RF power of 120 watts.
It has built-in lithium batteries, does not need external power supply, and is very convenient to use,
especially in outdoor portable applications. The mAT-125E does not need a control cable to
connect the transceiver. It only needs an RF cable to connect the transceiver to work well.
It will tune dipoles, verticals, Yagis, or virtually any coax-fed antenna. It will match an amazing
range of antennas and impedances, far greater than some other tuners you may have considered,
including the built-in tuners on many radios.
The mAT-125E has 16,000 frequency memories. When tuning on or near a previously tuned
frequency, the mAT-125E uses “Memory Tune” to recall the previous tuning parameters in a
fraction of a second. If no memorized settings are available, the tuner runs a full tuning cycle,
storing the parameters for memory recall on subsequent tuning cycles on that frequency. In this
manner, the mAT-125E “learns” as it is used, adapting to the bands and frequencies as it goes. You
can also start a tuning cycle manually whenever necessary. The tuner has four fine-tuning buttons.
After automatic tuning, you can make more fine adjustments manually to get a lower SWR.
Two 18650 lithium batteries are installed in the interior of the mAT-125E, which provides power
for the tuner. Because of the use of advanced magnetic retaining relays, the power consumption of
mAT-125E is very small, the lithium battery can work for a long time after it is fully charged. It is
very suitable for outdoor use. Special chargers are provided with tuners. You must use its own
charger to charge the tuner. It is dangerous to charge with an incorrect charger.
SPECIFICATIONS
- 0.1 to 120 watts SSB and CW peak power, 30 watts on PSK and digital modes, and 100 watts
on 6 meters.
- Latching relays for ultra-low power operation.
- 16,000 memories for instantaneous frequency and band changing.
- Tuning time: 0.1 to 5 seconds full tune, 0.1 seconds memory tune.
- 1.6 to 54.0 MHz coverage. Built-in frequency sensor.
- Tunes 5 to 1500 ohm loads.
- Includes a lithium battery charger.
- For dipoles, verticals, Vees, beams, whip, wire or any coax-fed antenna.
- Dimensions: 20cm x 13cm x 4cm (L x W x H).
- Weight: 0.8Kg.
NOTE: Before the first use or after the battery is replaced, the tuner must be charged by
the charger to activate the internal protection circuit before it can be used normally.
Question and Answer IconNeed help?

Do you have a question about the Mat-Tuner mAT-125E and is the answer not in the manual?

Mat-Tuner mAT-125E Specifications

General IconGeneral
BrandMat-Tuner
ModelmAT-125E
CategoryTuner
LanguageEnglish

Summary

Introduction to the MAT-125E Tuner

Key Features and Benefits

Describes the universal automatic antenna tuner, its frequency range, power handling, convenience, and antenna matching capabilities.

MAT-125E Specifications Overview

Performance and Technical Specifications

Covers power ratings, memory capacity, tuning times, frequency coverage, load impedance, and antenna types supported.

Physical Characteristics

Details the dimensions and weight of the MAT-125E antenna tuner.

Power Level Warnings and Limitations

Maximum Power Input Warning

Warns that exceeding the 120W maximum power input can damage the tuner or transceiver.

Front Panel Controls and Indicators

Pushbuttons and LED Layout

Details the six pushbuttons (TUNE, CUP, CDN, LUP, LDN, POWER) and four LED indicators on the front panel.

SWR and Power Indicator Lights

Explains the function of the 1.5, 2.0, >3.0 LEDs for SWR and the PWR LED for power status.

Rear Panel Connectors

Antenna, RF IN, Charger, and Ground Ports

Describes the function of the ANTENNA, RF IN, Charger, and GND connectors on the rear of the unit.

MAT-125E Installation Guide

General Installation and Safety Notes

Advises on indoor use, weather protection, and turning off the radio before connecting/disconnecting cables.

Critical Safety Warnings

Highlights high voltage inside when working and warns against touching the antenna during transmission.

Transceiver Compatibility Requirements

Outlines conditions for transceiver use, including power level and mode requirements, noting Yaesu sensitivity.

Connection and Grounding Procedures

Details connecting transceiver to RF IN, antenna to ANTENNA, and grounding recommendations.

MAT-125E Operation Modes and Tuning

Tuning Signal Requirements

Specifies required RF signal power (1-20W) and modes (CW, FM, FSK, RTTY) for tuning.

Automatic and Semi-Automatic Modes

Explains the two operating modes and how users can switch between them.

Tuning Procedure and VSWR Display

Guides on how to initiate tuning and interpret VSWR via front panel lights.

Manual Fine-Tuning

Describes how to manually adjust the LC tuning network using specific buttons.

Online/Bypass State Switching

Explains how to switch between online and bypass states using the TUNE key.

Combination Key Functions

Details how to use combination keys for mode switching, saving data, and online/bypass control.

Advanced Features and Maintenance

Automatic Shutdown Function

Describes the auto-shutdown feature for saving energy and how to enable/disable it.

Indicator Lights on Startup

Explains what the LED flashes on startup indicate regarding mode and shutdown function status.

Battery Replacement and Activation

Details battery type, capacity, and the initial charging requirement for the protection circuit.

Comprehensive Safety Precautions

Covers warnings about operating with cover removed, accessible terminals, and lightning storm precautions.

Transport Guidelines

Provides instructions on complying with local laws for transporting the tuner due to its batteries.

Technical Support Information

Offers contact details and website addresses for technical support and product information.

Product Feedback and Resources

Encouraging Product Feedback

Invites users to share their experiences and feedback on the MAT-TUNER product.

Website Resources and Dealer Information

Directs users to websites for product manuals, specifications, photographs, and dealer information.

Related product manuals