Need help?Do you have a question about the Matco Tools MD251 and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Display | LCD |
| Diode Test | Yes |
| Continuity Test | Yes |
| Safety Rating | CAT III 600V |
| Temperature Range | -40°C to 1000°C |
Defines WARNING and CAUTION terms used in the manual.
Details double insulation and measurement category ratings for the meter.
Explains IEC categories II, III, and IV for measurements.
Lists specific warnings and cautions for safe operation.
Identifies common electrical symbols used on the instrument.
Mentions compliance with CENELEC directives.
Identifies and describes the main components and controls of the multimeter.
Explains the purpose and use of the analog bar-graph display.
Explains the RMS measurement technique using average sensing.
Details True RMS measurement and potential causes of errors.
Explains Crest Factor, NMRR, and CMRR for meter performance.
Advises testing voltage function on a known source before hazardous measurements.
Shows DC voltage measurement setup and display.
Shows AC voltage measurement setup and display.
Explains how to activate and use the Hz function.
Details resistance measurement using the meter.
Explains how to use the continuity test function.
Describes how to perform diode tests and interpret results.
Warns about discharging capacitors before measurement.
Shows DC millivolt measurement setup.
Shows AC millivolt measurement setup.
Details DC current measurement modes.
Details AC current measurement modes.
Explains Non-Contact and Probe-Contact EF-Detection.
Describes the Hold and Relative Zero (Δ) functions.
Explains how to switch between manual and auto-ranging.
Describes how to set the beeper and input warning functions.
Explains the Auto-Power-Off feature and its disabling.
Warns about safety precautions during maintenance.
Lists battery type and fuse ratings for replacement.
Details the steps for replacing batteries and fuses.
Lists display details, temperature, humidity, and altitude specs.
Details safety standards and EMC compliance.
Specifies measurement categories and overload protection limits.
Lists power supply, consumption, dimensions, and weight.
Provides accuracy and input impedance for AC voltage ranges.
Details accuracy and open circuit voltage for resistance ranges.
Provides accuracy and input impedance for DC voltage ranges.
Lists specs for continuity and diode testers.
Provides accuracy and burden voltage for current ranges.
Details specs for EF-Detection and Hz functions.
Outlines the limited warranty terms and conditions for the product.
To Next Page
