MT1874 6" Heavy Duty DA Sander
Matco warrants its air tools for a period of 1 year to the consumer. We will
repair any MT Series air tool covered under this warranty which proves to
be defective in material or workmanship during the warranty period. In order
to have your tool repaired, return the tool to either of the Matco Authorized
Warranty Centers listed below, freight prepaid. Please include a copy of your
proof of purchase and a brief description of the problem. The tool will be
inspected and if any part or parts are found to be defective in material or
workmanship, the tool will be repaired free of charge and returned to you
This warranty gives you specific rights. You may also have other rights which
vary from state to state.
The foregoing obligation is Matco’s sole liability under this or any implied
warranty and under no circumstances shall Matco be liable for any incidental
or consequential damages.
Some states do not allow the exclusion or limitation of
incidental or consequential damages so the above limitation or exclusion may
North Las Vegas, NV 89030
Tools of this class operate on a wide range of air pressures. It is
recommended that air pressure of these tools measures 90 PSI
at the tool while running free. Higher pressure and unclean air
will shorten tool life because of faster wear and may create a
Water in the air line will cause damage to the tool. Drain the
air tank daily. Clean the air inlet filter screen on at least a weekly
schedule. The recommended hook-up procedure can be viewed
The air inlet (Figure 2), used for connecting air supply, has standard
Line pressure should be increased to compensate for unusually
long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and
fittings should have the same inside dimensions.
Other factors outside the tool may cause loss of power or erratic
action. Reduced compressor output, excessive drain on the air
line, moisture, restrictions in air pipes, the use of hose connections
of improper size or poor conditions may reduce air supply. If
outside conditions are in order and the tool still performs erratically, disconnect
tool from hose and take tool to your nearest Matco authorized service center.
LUBRICATION & MAINTENANCE
Lubricate the tool daily with a good grade of air tool oil. If no
air line oiler is used, run a teaspoon of oil through the tool. The oil can
be squirted into the tool air inlet Figure 1, or into the hose at the nearest
connection to the air supply, then run the tool. A rust inhibitive oil is acceptable
• Super new sander weighing 20% less than most competitive models (3.85 lbs.),
but providing over 20% more power
• Special handle muffler system for quite operation
• New design air intake and exhaust design, allows maximum speed almost instantly
• Molded handle grip for extra comfort
• Special molded head design makes for outstanding control and comfort
MT1874_011206_OpMan.indd 3 1/12/06 2:41:43 PM
To Next Page
Loading...