To Next PageTo Next Page
Need help?Do you have a question about the Matermacc IRRIGAMATIC P450 and is the answer not in the manual?
Details the conditions under which the manufacturer's warranty is valid and expires.
Procedure for turning the electronic console on.
Automatic tests and preliminary operations performed by the console.
Indicates when the console is ready for programming after startup.
Optional signal for programmed hose quantity unwound.
How to manually input or correct unwound hose meter readings.
Overview of setting up the irrigation cycle parameters.
Setting the desired time for the irrigation cycle to begin.
Configuring a delay before the irrigation cycle starts.
Setting speed and length for the first irrigation sector.
Setting speed and length for the second irrigation sector.
Setting speed and length for the third irrigation sector.
Setting speed for the fourth irrigation sector.
Setting a delay after the irrigation cycle completes.
Procedure to initiate the programmed irrigation cycle.
Monitoring and progress of the irrigation cycle.
Information displayed by the console during the working cycle.
Advanced information display during operation.
Display information related to time-limited irrigation.
Display information for irrigation ending based on meters rewound.
Steps and displays for completing the irrigation cycle.
Setting up signals for programmed hose unwinding quantities.
Ending irrigation based on a specific number of meters rewound.
Setting a time constraint for the irrigation cycle completion.
Procedure for setting the irrigation cycle's time limit.
Steps to enter the sensor testing mode.
Testing the functionality of various console sensors.
Messages indicating normal operation or status.
Messages related to the irrigator trolley's movement and status.
Indication that the irrigation cycle has concluded.
Messages indicating faults or abnormal conditions.
Messages indicating issues with irrigation time calculations.
Messages related to the end-of-rewinding sensor status.
Errors in programmed meter values compared to actual unwound meters.
Messages indicating motor control actions.
Checking the charge status of the power supply battery.
Restoring programmed values for a new cycle.
Erasing programmed values and resetting the console.
Manually increasing or decreasing motor speed.
Manually opening or closing the end-of-work valve.
General
