Rev. Descrizione Redatto/Gestito Approvato Cod.Ident. Pagine Data Em.
0.6 Manuale Istruzioni GN UTEC B041.M01.EN 47/47 07/2014
Take the mould out of the testing chamber and put it on the extruding piston.
Check that the lower collar of the mould is well contained between the three contrast pins of the specimen
extruder.
DANGER
Do not touch the mould and any part of the
extruder during the extruding phase, to avoid
fingers crushing.
Vertical force testing device (B041
Digital vertical force testing device (B041
To Previous Page
Loading...
