24-Bit /192kHz High Performance Stereo Audio Processor
MATRIX
- 5 -
Headphone Output
The high-quality standard 1/4”stereo headphone plug-jack on the front panel
can drive any headphone of 300 ohms and below, which makes it very
convenient to use your headphone. Use the Volume Control Knob on the front
panel to adjust the volume.
When the Amplifier on the front panel is switched to the position of Internal, the
Amplifier will be connected to the internal output of CUBE and directly monitor the
output signal.
When it is switched to External, the Amplifier will be connected to the external
input and monitor external input audio signal. Meanwhile, the circuit units of CUBE
work unaffectedly.
Coaxial Digital Output
CUBE possesses a coaxial digital output. The output state depends on the
condition of the output channel. This channel directly outputs current digital
signals. When the ASRC on the front panel is switched off, CUBE will output the
original code such as AC-3, DTS and so on. When the ASRC is turned on, Cube will
increase the sampling rate to 176.4KHz/192KHz. It is also very convenient to
connect it with other digital audio equipment or AC-3, DTS decoders.
USB Driver
CUBE’s USB interface works under Win 2K / Win XP / Vista / 7, Linux, Mac OS X, but
it does not support AC-3, DTS stream signal transmission. To improve this, installation
of the USB driver provided by MATRIX is suggested. By doing so, you can also set
Xear™ Virtual 3D processing and 10-band equalizer.
● Trouble shooting
Check the following before calling for service:
z Whether all the connections have been done correctly or not
z Whether your CUBE is properly operated or not
If your problems cannot be solved by the remedies listed in the following table, it might
due to the malfunction of CUBE’s internal circuitry. In this case, please immediately
unplug the power cable and contact the MATRIX distributor.
To Next Page
Need help?
General