5
ASSEMBLY
ENGLISH
1) Install the console bracket onto the
handlebar then slide the foam sheet
between the handlebar and console
bracket.
2) Install 4 AA batteries into the console.
3) Attach the console to the console
bracket using 2 screws.
4) Remove the 4 screws and the
handlebar adjustment knob then
remove the plastic cover.
5) Plug the unused wire into the RF
Sensor.
Install the RF SENSOR
CR2032 battery with the
positive side up. Replace the
battery when is flashing
on the console.
6) Using the Velcro, mount the RF
Sensor to the Main Frame.
7) Reinstall the plastic cover and
handlebar adjustment knob.
5
4x AA
To Next Page
Loading...
