13
turning off the motor.
• All protective and safety equipment must
be reinstalled immediately upon completion
of any repair or maintenance work.
REGULAR MAINTENANCE
The regular maintenance described above
and in the paragraph below can be carried
out by unskilled personnel.
• Do not oil the mitre saw because cutting
must be always be carried out in dry
conditions; all rotating parts are self-
lubricating.
• During maintenance, wear protective gear
if possible (accident-prevention goggles
and gloves).
• Remove cuttings when necessary both
from the cutting area, work surfaces and
support bases. Make sure to turn off and
unplug the saw before doing so.
Use of a vacuum cleaner or brush is
recommended.
WARNING:
Do not use compressed air
jets!
• Regularly check blade conditions: if
difculties should arise during cutting, have
your blade sharpened by skilled personnel
or replace it if necessary.
ASSISTANCE
When in need of skilled personnel for
special maintenance, or for repairs, both
during and following the guarantee period,
always apply to authorized centres for
assistance or directly to the manufacturer if
there is no authorized centre in your area.
Disposal of the machine
Once its operating activity is nished, the
disposal of the machine must take place
through a standard Collection and Disposal
Centre for industrial waste.
Please contact your municipality for
available services in your area.
To Next Page
Loading...
Need help?
General
