What to do if the motor of Matrix Saw does not run?
If the motor of your Matrix Saw does not run, the issue may stem from a faulty motor, power supply cable, plug, or burned-out fuses. Have the machine checked by skilled personnel and check the fuses and replace them if necessary. Remember, attempting repairs yourself can be dangerous.
Why does the motor of my Matrix TRS 1200-56 Saw overheat easily?
If the motor of your Matrix Saw overheats easily, it could be due to motor overload or inadequate cooling. To resolve this, avoid overloading the motor during cuts and remove any dust from the motor to ensure optimal cooling.
What to do if the Matrix Saw motor does not reach full power?
If your Matrix Saw motor isn't reaching full power, it might be due to an overloaded circuit from other appliances. To fix this, avoid using other utilities or motors on the same circuit as the saw.
How to fix a rough or wavy saw cut with my Matrix Saw?
If your Matrix Saw produces rough or wavy cuts, the saw blade may be dull or not suited for the material's thickness. Try re-sharpening the blade or using a more appropriate one.
What to do if the work piece rips or splinters when using Matrix TRS 1200-56 Saw?
If the work piece rips or splinters when using your Matrix Saw, it could be due to excessive cutting pressure or an incorrect saw blade. Ensure you are using the correct saw blade for the application.
Why does the Matrix TRS 1200-56 motor start slowly?
If your Matrix Saw motor starts slowly and doesn't reach full speed, it could be due to low power supply voltage, damaged windings, or a burned-out capacitor. Contact the Electricity Board to check the voltage. Have the motor and the capacitor checked/replaced by skilled personnel.
Why is there excessive motor noise coming from my Matrix TRS 1200-56?
If you notice excessive motor noise in your Matrix Saw, it may be caused by damaged windings or a faulty motor. Have the motor checked by skilled personnel.
How to fix decrease in cutting power when sawing with Matrix Saw?
If you experience a decrease in cutting power when using your Matrix Saw, the saw blade might be too small (sharpened too often). Try re-adjusting the end stop of the saw unit.
General| Saw type | Table saw |
|---|---|
| Power | 1200 W |
| Blade diameter | 210 mm |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Motor Power | 1.2 kW |
To Next Page
