32
Check for loose attachments, especially on the
cutting set and shoulder strap, fuel leaks and
damaged parts, such as for example cracks in
cutting unit (visual inspection).
Also, visually inspect each time the device is
dropped and after any other impact to identify
signicant defects.
Weekly examination: Gear lubrication (also as
required).
If necessary: Tighten accessible fastening screws
and nuts.
You will avoid excessive wear and damage to
the device if you follow the instructions in this
manual.
The user is responsible for all damage caused by
non-observance of the instructions given in this
manual.
This also applies to unauthorized modications
to the device, use of unauthorized spare parts,
add-on parts, work tools, non-conforming and
improper use, consequential damage through
the use of defective components.
Always keep the device and all cutting
equipment and protective equipment in good
working condition.
To Next Page
Loading...
