41
Assembly of the pipes
1. Place the tube with the drive head (lower pipe)
and the upper pipe on a clean, even surface, so
that both ends can be inserted into each other.
The tube with the drive head (lower pipe) and
the bolt guard of the upper pipe must point
upwards.
Caution! The open ends of the tubes must be
clean and free of dirt!
2. Loosen the screw of the connector.
3. Press the latch down and push the tube with
the drive head (lower tube) into the connector
as far as it will go. Release the latch. Slide the
top tube back and forth until it snaps into the
connector. See A 39.
A39
4
3
5
6
2
1
1). Latch
2). Latch protection
3). Indent
4). Tube with drive head (lower pipe)
5). Connecting piece
6). Screw of the upper tube
7). Screw of the connecting piece
4. If the two tubes are connected to one another,
slide the latch guard into the notch and tighten
the screw on the connecting piece. See A 40.
A40
2
5
7
Disassembly of the tubes
1. Place the hedge trimmer on a clean, even
surface and loosen the screw of the connecting
piece. Pull the latch protection out of the notch.
2. Press the latch down. This triggers the locking
of the connector. See A41.
Press the latch
down
A41
3. Pull the upper tube out of the connector.
Assembly of the cutting attachment
Warning!
The blades are very sharp. Do not handle the
blades if the blade cover is not covered. Wear
gloves always, if you work with the blade or in its
vicinity.
1. Make sure the cutting attachment is locked in
the storage / transport position (folded back) and
the blade cover is pulled over the blades.
2. Push the outer tube into the clamping of
the gearbox housing as far as it will go. The
outer tube must be pushed completely into the
gearbox housing. If you feel resistance in front of
the stop, turn the outer tube until the wedges of
the inner main shaft (drive shaft) engage in the
To Next Page
Loading...
