3.0 ADJUSTING THE SEAT HEIGHT
Your MATRIX Cycle is designed for ease of use. We have incorporated seat height adjust-
ments that are easily located and simple to adjust.
3.1 UPRIGHT SEAT HEIGHT
To adjust the seat height on the Upright Cycle, locate the yellow pull pin before you mount
the Cycle. To lower the seat down, pull the yellow knob while holding the seat with the other
hand and slide up or down accordingly. To adjust seat height up, simply raise the seat to
desired position. Our automatic seat lock will set. Make sure you are not seated when you
pull the knob or pull seat up.
3.2 RECUMBENT SEAT HEIGHT
To adjust you’re seat height on the Recumbent Cycle locate the yellow lever under the right
side of the seat before you mount the Cycle. Place your right hand on the yellow adjustment
handle under the right side of the seat. Place feet on the ground while seated and slide for-
ward if needed. Place feet on pedals, gently lift lever under the right side of the seat. Using
legs slowly push and slide the seat up or down to desired position. Release lever and allow
to lock into place.
3.0 AJUSTING THE SEAT
3
To Next Page
Loading...
Need help?
General
