11 Matrix SATATYA NVR Quick Start
NVR6408X
•1 Cable Mains 3 Pin
• 32 HDD fitting screws
•8 HDD SATA Cable
•2 Clamps for Rack Mounting
Things You Will Need
• A Power Hand Drill
• A Wire Stripper
• Insulation Tape
• A Screwdriver set
• Cameras (IP Cameras, PTZ cameras).
• Monitors (HDMI) with the appropriate cables to connect.
• At least one SATA Video Surveillance Hard Disk (upto 10TB), if you want to record on a hard
disk in the NVR. You can install eight hard disks.
• A USB Mouse or Keyboard (Wired or Wireless) to operate the NVR, if required.
• A personal computer or a LAN computer with a browser installed on it (Internet Explorer,
Mozilla Firefox, Google Chrome), if you want access the NVR from a remote location.
• Any audio device you want to connect with cables.
• An Ethernet cable to connect to a computer/LAN/WAN (over a DSL Modem or Router).
• Insulated copper wires (wire range: 28-16 AWG, 0.5 -1.5mm
2
), if you want to connect
sensor and alarm devices.
• A rack, if you want to mount the NVR on a rack.
Preparing for Installation
• Select a suitable location after reviewing your video surveillance layout requirements, cable
runs and power needs.
• The SATATYA NVR is meant for indoor installations only.
• The SATATYA NVR unit can be mounted on a rack or placed on any stable flat surface
such as a desk.
• Select a suitable location for installation taking the following recommendations into
consideration. The location should
• be secure, yet easily accessible for servicing the equipment.
• not expose the device to extreme heat or moisture, high voltages.
• have adequate ventilation to prevent overheating.
• be clear of any obstructions to the ventilation holes on the side panels of the NVR.
• have a power outlet close by.
To Next Page
Loading...
Need help?
General
