Ingress Protection Accessory Installation
1. The Ingress Protection Accessory comprises of the following:
Holder, Rubber, Cap and O-Ring.
You need to pass the RJ45 cable with connector through each in the
sequence as shown below.
Now, insert the Rubber into the Holder and then place the Cap.
Accessing Reset Switch
If you forget the IP Address or Login credentials then the camera can be
reset to factory default settings using the Reset Switch.
• The Reset Switch is connected along with the main input Cable
Assembly as shown in Figure 11.
• There is a rubber cap on the Switch to protect it from dust, see
Figure 12. Remove the cap and press the Reset Switch for minimum
5 sec and release the Switch to reset the camera settings to default.
Figure 11
19
20
Reset Switch
Rubber Cap
Figure 12
Ingress protection accessory
Cap
Rubber
Holder
RJ45
Connector
To Next Page
Loading...
