5. Gently bend back the plastic tab blocking the slot, and insert Antenna.
6. Route the wire on top of the UCB, securing with tape to prevent movement.
7. Connect the Antenna to the Wi-Fi Board. Either Antenna can connect to either socket.
8. Install the Fan Bracket.
9. Install the Console upper rear shroud.
TouchXL reference: W59
Touch reference: W58 (Left), W59 (Right)
Console photo index: 12a (Touch or TouchXL)
Wi-Fi /Bluetooth Board
Remove the Wi-Fi board by removing 1 #2 Phillips. The board will tilt upwards; pull away in line with the
Wi-Fi board. To install, align connector and insert at ~30 degree angle. Gently press to tilt down,
aligning board cutout with screw boss; insert screw.
Follow these steps to replace this part.
1. Remove the Console upper rear shroud.
2. Remove the Fan Bracket.
3. Detailed replacement instructions are under development.
4. Install the Fan Bracket.
5. Install the Console upper rear shroud.
TouchXL reference: 12
Touch reference: 12
Console photo index: W34 (Touch or TouchXL)
To Next Page
Loading...
