4. Press down gently on the microSD to release; it should freely pull up and away.
5. Carefully align the new microSD into the socket; press down gently until it locks into place.
6. Install the Fan Bracket.
7. Install the Console upper rear shroud.
TouchXL reference: W34
Touch reference: W34
Console photo index: N/A
Wi-Fi Antenna
Antenna usually do not need to be replaced if replacing the Wi-Fi board. If the antenna wire is tugged
on, it can be easily removed from the board at the opposite end than the Wi-Fi board itself. They would
need to be replaced at that time. Always route the antenna wire so it can-not be snagged on anything.
Follow these steps to replace this part.
1. Remove the Console upper rear shroud.
2. Remove the Fan Bracket.
3. Carefully disconnect the antenna wires from their sockets on the Wi-Fi Board; remove any tape
securing the wires to the UCB or console.
4. Gently bend back the plastic tab securing the Wi-Fi Antenna in its slot, and pull Antenna out.
Touch consoles have two distinct antenna, with different wire lengths. TouchXL consoles use two of the
same antenna.
To Next Page
Loading...
