Disassembly & Reassembly Reference
Each of these short instructions provide a reference to a portion of console disassembly & reassembly.
They are meant to be used as general-purpose support when replacing an underlying part – a means to
an end. Review these instructions when needed during console service and part replacement.
Removing the Console upper rear shroud
1. Remove 4 #2 Phillips from the corners of the upper rear shroud.
2. Gently lift shroud away from console.
Remove the Fan Bracket may be next.
The following components can be accessed by with no further disassembly:
• CSAFE/CAB Board
• Fan
• Speaker
• Backlight Board (TouchXL only)
To Next Page
Loading...
