TouchXL reference: N75
Touch reference: Not installed
Console photo index: 13 (TouchXL)
BT Sync/GymKit Board
This board allows syncing of a phone or other Bluetooth device with the console to allow media
playback & control on the console.
It also allows Apple GymKit connectivity.
Follow these steps to replace this part.
1. Touch only: Remove the Console from the Frame.
2. Touch only: Remove the Console Frame from the Console.
3. TouchXL only: Remove the Console upper rear shroud.
4. Detailed replacement instructions are under development.
5. TouchXL only: Install the Console upper rear shroud.
6. Touch only: Install the Console Frame into the Console.
7. Touch only: Install the Console on the Frame.
TouchXL reference: W20
Touch reference: W20
Console photo index: 14 (Touch or TouchXL)
CSAFE/CAB Board
One external port is merged to provide connectivity for external TV audio passthrough via 900/863MHz
devices as well as CSAFE data from devices such as CAB, CableSAT, and Fitlinxx. These functions are
separated to each internal port; both internal or the single external can be used, but not internal &
external ports at the same time.
Do not connect ethernet to any of these ports.
Follow these steps to replace this part.
1. Remove the Console upper rear shroud.
2. Remove 3 screws with #1 Phillips screwdriver.
3. Unplug the wire and ground.
4. Plug in the new board.
To Next Page
Loading...
