12. Carefully lift console frame away, ensuring no connections were overlooked or tangled; set
aside.
Removing the Console Frame is required to service the following components:
• BT Sink/GymKit Board
• ANT+/HR Board
• Energy Saver LED
• Console Proximity Sensor
• USB port
• Display
• Touch Panel
• UCB (Touch consoles)
Installing the Console Frame in the Console
1. Loosely place frame in console, and make the following connections.
2. Align & connect the cable to UCB socket J24 (Blower).
3. Align & connect the cable to UCB socket JP3 (Speaker).
4. Align & connect the cable to UCB socket J16 (CSAFE).
5. Align & connect the cable to UCB socket J19 (CAB).
6. Route the ANT+/HR cable through frame rail (lower left).
7. Align 6 screw holes in console frame vertical rails to their bosses in front panel. Ensure no wires
are pinched or bound; affix with 6 #2 Phillips.
8. Reattach the ANT+/HR cable fixing strap to the frame rail (lower left) with 1 #2 Phillips.
9. Reconnect the ANT+/HR Ground lead to the console frame (bottom left) with 1 #2 Phillips.
10. Reconnect the USB Ground lead to the console frame (lower right) with 1 #2 Phillips.
Install the Console on the Frame is likely next.
Installing the Console on the Frame
1. Install lower rear console shroud. Affix with 4 #2 Phillips.
2. Install upper rear console shroud. Affix with 4 #2 Phillips.
3. Ensure the frame power switch is off or power cord unplugged.
4. Carefully place console on frame bracket, ensuring no cables are pinched.
5. Loosely insert 1 or 2 6mm console mount bolts in LOWER threads to prevent console from
falling.
6. Route mast cables BETWEEN console frame rails, and make the following connections:
o Console Cable to UCB socket J2 (MCB).
o External Power cable from UCB socket J25 (14V INPUT).
o Button cable to UCB socket CN9 (KEY2).
o Button cable to UCB socket JP5 (KEY3) (two cables come together in one connector).
o Frame Earphone cable to UCB socket J20 or J21 (EARPHONE), if installed.
o HR cable to wire connector within console (6 conductor, 2x3) (two cables come together
in one connector).
o If installed, Emergency Stop from UCB socket J4 (E-STOP).
o Coax cable to Tuner.
To Next Page
Loading...
