• Verify that the ribbon cable wasn’t inadvertently pulled from its socket on the board –
no white line should be visible.
26. Install the Wi-Fi board to UCB socket CN5.
• Align board to socket, inserting at ~30 degree angle; gently press down to level with
UCB; affix with 1 #2 Phillips screw.
• Verify both antenna wires connecting to Wi-Fi board remained properly attached.
27. Reaffix RFID & Wi-Fi antenna wires with tape.
28. Touch only: Install the UCB.
29. Install the Console Frame into the Console.
30. Install the Console on the Frame.
TouchXL reference: AW35
Touch reference: AW35
Console photo index: 23 (Touch or TouchXL)
Earphone Board
There is an insertion counter built into the console software. When the insertion count reaches 3,000,
an error will display on the screen indicating it’s time to replace the board. In order to clear the error,
you must go to the Service Mode and reset the counter. After a new board is installed, reset the counter
again.
The Headphone Board is accessible from the front of the console; no other disassembly is required.
Remove 2 #2 Phillips screws from the Headphone Board bracket and gently pull out of console.
TouchXL reference: W81
Touch reference: W81
Console photo index: 21 (Touch or TouchXL)
Energy Saver LED & Console Proximity Sensor
The LED lights up to indicate that the console is ‘asleep’ in Energy Saver mode.
The Console Proximity Sensor detects a user’s approach to ‘wake’ the console.
Follow these steps to replace this part.
1. Remove the Console from the Frame.
2. Remove the Console Frame from the Console.
3. See images below for replacement instructions.
4. Install the Console Frame into the Console.
To Next Page
Loading...
