Follow these steps to replace this part.
1. Remove the Console from the Frame.
2. Remove the Console Frame from the Console.
3. Detailed replacement instructions are under development.
4. Install the Console Frame into the Console.
5. Install the Console on the Frame.
TouchXL reference: W53
Touch reference: W53
Console photo index: 22 (Touch or TouchXL)
Backlight Board (TouchXL only)
The Backlight Board allows the UCB to drive the larger 22” display of the TouchXL.
There currently isn’t good knowledge about what happens when this board fails, or how to troubleshoot
issues with it.
Follow these steps to replace this part.
1. Remove the Console upper rear shroud.
2. Disconnect the cables from both sockets on the Backlight Board.
3. Remove two #2 Phillips screws
The Backlight Board can now be lifted away from the console.
Align the Backlight Board with the screw bosses to install
4. Affix with two #2 Phillips screws.
5. Connect the UCB & Display cables to the available sockets on the board.
6. Install the Console upper rear shroud.
To Next Page
Loading...
