Revised: March 2021 I Revised By: BNelson Page 10 of 15
Varsity Series
The machines using the cable clamp will have a ball end cable (above weight stack) with a cable stopper
at the user end of the cable. The cable tension for these machines is based on the cable stopper position
to the pulley.
Cable Clamp
Cable Tensioning Procedure:
1. Remove/loosen the clamp bolts from the clamp on top of the weight stack
2. Move the cable ball end to the middle adjustment slot and check the distance of the cable
stopper to the pulley
3. Check cable stopper position in relation to the pulley
4. Tighten the clamp bolts using a wrench
To Next Page
Loading...
