Revised: March 2021 I Revised By: BNelson Page 5 of 15
Versa Series
Versa Series single stations use a ball end cable at the top of the weight stack. The cable is secured to
the head plate by a jam nut locking it in place. To adjust the cable tension, you must use the adjustment
on the lower part of the weight stack frame.
Cable Tensioning Procedure:
1. Loosen the two bolts circled in the picture below. Do not remove
2. Using a 6mm Allen socket, turn the adjuster bolt (shown with the arrow) down a few turns.
This will push the cable pulleys lower giving the cable tension
3. Check for proper tension
4. Tighten the bolts from Step 1 once the proper cable tension has been achieved
To Next Page
Loading...
